How to correctly install and remove ABS handheld showerheads?

Installation steps
Close the water valve: Before installing the ABS handheld showerhead, be sure to close the main water valve first to avoid accidental water spraying during installation.
Preparation tools: Prepare the necessary tools for installation, such as wrenches, raw tape, etc.
Installation base: Align the base of the ABS handheld showerhead with the wall outlet, and use a wrench to tighten the screws. Before tightening the screws, a suitable amount of tape can be wrapped around the screws to enhance sealing and prevent water leakage.
Install shower rod: Insert the shower rod into the fixed hole of the base and adjust it to the appropriate height. Use a wrench or screwdriver to secure the showerhead rod.
Connecting hose: Connect the hose of the handheld showerhead to the showerhead rod, ensuring that the connection is tight and leak free.
Open the water valve test: Open the main water valve and check if the handheld showerhead is securely installed and if there is any water leakage. If there is water leakage, it is necessary to promptly close the water valve and recheck the installation steps.

Disassembly steps
Close the water valve: Before disassembly, it is also necessary to close the main water valve to avoid accidental water spraying during the disassembly process.
Disassemble the hose: Separate the hose of the handheld showerhead from the showerhead rod. This can usually be done by rotating or pressing the release button on the hose connector.
Dismantling the showerhead rod: Use a wrench or screwdriver to remove the showerhead rod from the base.
Dismantling the base: Use a wrench to loosen the screws on the base and remove the base from the wall outlet.
Cleaning and Preservation: Clean the disassembled components to remove scale and impurities, and store them properly for future use.